Users Manual

对折基准 线
对折基准 线
3
Installation
A mounting gasket has been added inside the package for convenience. Trace along
the outside edge of the gasket thus revealing your cutout.
Mounting Illustration
1. Avoid installing stereo
below cupholders!
Make sure mounting
substrate is flat to avoid
flexing of the plastic.
2. Use the back bracket and
studs to affix the unit. Install
the U bracket behind the unit,
using two nuts per bolt for
ultra hold.
3. To avoid possible water
ingress into wire harness
area, route the harness in
the downward direction
as shown above.
Instructions:
1. Install jamb nuts (4) loosely on mounting
studs (3), so they will not touch mounting
brackets (5) when installed.
2. Slip mounting bracket (5) on and make
flush with mounting surface (2).
DO NOT TIGHTEN
3. Snug spring washer (6) and outer nuts (7)
against mounting plate (2).
DO NOT TIGHTEN
4. Position jamb nuts (4) approximately
1/16” from mounting bracket.
5. Tighten outer nuts (7) completely.
14
4. Track Up/Down
While USB is playing, press button to select next track and press
select the previous track.
To fast forward , press and hold button.
5. Repeat/ Random/ Scan Play
While USB is playing, repeatedly long press MENU button to switch among Repeat One,
Repeat All, or Random play.
Long press MUTE button to switch to Scan play. Long press MUTE again to disable Scan
function.
6. Track Search
While USB is playing, short press MENU button to enter track search mode, it will display
all the tracks in current playing Directory.
- To select other tracks in current directory, just simply turn VOL knob and press the knob
at desired track.
- To select the tracks in other directory, press Return button at the track display screen, it
will back to directory display, turn VOL knob and press the knob at desired directory,
repeat above operation until a track selected.
button to
To fast rewind, press and hold button.
USB Section Operation