PROSPEC ELECTRONICS prospecelectronics.com | 843.849.
INSTALLATION BULLETIN To avoid possible water ingress into wire harness area, route the harness in the downward direction as shown below on the left. Do not route the harness in the upward direction as shown on the right. Installation Instructions 1 2 3 4 5 6 7 Instructions: 1. Install jamb nuts (4) loosely on mounting studs (3), so they will not touch mounting brackets (5) when installed. 2. Slip mounting bracket (5) on and make flush with mounting surface (2). DO NOT RIGHTEN 3.
PRV-175 Troubleshooting *Note: In many respects, a stereo acts much like a computer and occasionally requires a reboot. In the unlikely event of product malfunction, a reset can usually fix the issue. Reset Function: While unit is powered on, press and hold SEL button until setting menu displays on the LCD, then quickly press the SEL button repeatedly to navigate to firmware version. With firmware version displayed, press and hold SEL button again until SYS CLR displays on the LCD and the unit reboots.
Product Description Installation This radio features Bluetooth technology allowing music to wirelessly stream from an audio source to the receiver you just purchased. Why Bluetooth? From a practical standpoint, Bluetooth enables your music device (if applicable) to be placed in a glove box, your overhead console, or even your pocket-places that are dry-without having to install a separate docking station.
Bluetooth Operation Front Panel Layout Your media device must incorporate the Bluetooth option in order to stream music. A. To pair your Bluetooth device, press the MODE button on the stereo until BT AUDIO appears. B. Press and hold SCAN button until PAIRING appears. C. Next, go to settings on the Bluetooth device and turn the Bluetooth option to “on”. C. Pick the “PRV-175” option on your Bluetooth enabled device (please note that if you are prompted for a password, the code entered will be “1234”.
Front Panel Layout Radio Operation VOL + Volume Increase A. Pres button (BAND function) to access FM and AM. There are three FM bands and two AM bands, each band contains six presets. VOL - Volume Decrease B. APS button (Auto Preset Store). Press and hold APS will automatically preset six stations into the current band. Track Up / Tune Up / Fast Forward C. SCAN button (Presets Scan). Simply press SCAN button to scan the preset stations in current band.