User Manual ThermalSense Hub Brand: PROSPACE Model:Hub 4.0TS BLE Mmanufacturer PROSPACE PTE. LTD.
BLE Hubs Thermalsense front Thermalsense act as a receiver for the BLE sensors signal to send `1` and `0` data to the cloud. Thermalsense back The Thermalsense can be put on the table or attached to the ceiling as show in picture 1.
How to connect the BLE Hubs 1. Use a micro USB to connect the back of the hub and connect the USB to laptop 2. Open Coolterm Software 3. Click option 4. Click on Re-Scan Serial Port 5. Ensure BaudRate is 115200 6. Ensure in Terminal Tab, Line mode is selected 7.
How to connect the BLE Hubs 1. Type in your network ssid “ssid:XXXXXXXXX” 2. Press enter 3. Type in your network password 4. “password:12345678” 5. Press enter 6. Type in Commit 7. Once connected you will see Picture 2 8. Under BLE line: you will see the BLE sensor ID appear inside when you connect the BLE chipset to the equipment.(Picture 3) 9.
The common place to deploy hubs are usually behind tv, under table, in Cabinet, above false ceiling It is preferred to have the buffer hubs place in an area.
Green Network light connected to wifi Network light(red) If no network After deploying all BLE hubs and recording them. Remember to ensure the hub have no red light Do contact back ProSpace if you need any help.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
