User`s manual

CONNECTING AUXILIARY COMPONENTS
AUDIO
RECEIVER
R
L
199
aivin
aivin
CD
PLA YER
CONNECTING A COMPACT DISC PLAYER
Using one paired (red/white) stereo cable,
connect your new receiver to your compact disc
player as shown to the right.
To play a CD, press CD, put the receiver in CD
mode and press PLAY.
NOTE:
The AUDIO SOURCE connection can be
used as input for any stereo audio signal.
PHONE
A/B/C/D
SCAN+FM/AM
SCAN-
NO.1-8
MEMORY
POWER
VOLUME - VOLUME+
AUTO
INPUT
STEREO RECEIVER AMPLIFIER RV2040
BEFORE YOU CONNECT.....
CONNECTING THE CABLES
-Protect components from power surges.
-Connect all components before plugging power
cords into the wall outlet.
-Always turns off the receiver and/or components
before you connect or disconnect any cables.
-Always make sure the color-coded plugs match
the colour of the terminals in which they are
inserted.
-The connection cable plugs and jacks are
color-coded as follows:
Speaker Terminals Red for positive (+) terminals.
Black for negative (-) terminals.
-Some units may be supplied with connection
plugs that are color-coded red and black instead
of red and white. In this case, the black plug
takes the place of the white plug.
POSITION CABLES CORRECTLY TO AVOID
AUDIO HUM OR INTERFERENCE
-Insert all cable plugs firmly into their jacks.
-Place audio/video cables to the sides of the
receiver's back panel instead of straight down
the middle after you connect the components.
-Try not to coil any power cables and keep them
away from the audio/video cables as much as
possible.
-Make sure all antennas and cables are properly
grounded. Refer to the Safety Tips sheet packed
with your receiver.
12