User`s manual

RECEIVER CONTROLS & OPERATIONS

VCR

REMOTE CONTROLS

1. Input selector buttons

Press these buttons to select a analog input source.

2.A/B/C/D button

Press the button to select a group of preset stations.

3.BASS Parameter selector button

Press the button to select bass tone. then press

"8" buttons to adjust the low-frequency response.

4.TREBLE Parameter selector button

Press the button to select treble tone. then press

"8" buttons to adjust the high-frequency response.

5.BALANCE Parameter selector button

Press the button to select balance. then press "8"

buttons to adjust the balance between left and right.

6.MUTE

Mute the sound.Press again to restore the audio out

to the previous volume level.

7.SLEEP button

Press the button repeatedly to turn the sleep timer

on and off, and set the sleep time(10-20-30-40-50-

60-70-80-90mins).

8.PARAMETER selected and MASTER VOLUME

adjustment buttons

To adjust parameter selected or main volume.

9.Standby button

Press this button to set this in the standby mode.

Press again turn on the power of this unit.

10.FM/AM band switches button

Press the button to select input source is tuner and

switch the reception band between FM and AM.

11.Number 1-8 button

Press the button to call preset station number on

the tuning status.

12.MEMORY button

Use the button to enter a station to memory.

13.TUNER automatically tuning button

Press and hold the button 3 seconds, All station

are browsed and stored automatically.

(AM/FM is detached)

14.TUNING SCAN+,SCAN- buttons

Press the SCAN+ side to tune in to a higher

frequency.

Press the SCAN- side to tune in to a lower

frequency.