User's Manual

RLX2 Industrial Hotspot Series

Page28of208 ProSoftTechnology,Inc.
 February5,2015

WARNING:DonotconnectordisconnectthePoEconnectionwhenenergized.
AntennasaretobeinstalledinaccordancewithControlDrawing06/2514.

ForRLX2‐IHNF‐WCRadios
ThisradioissuitableforClassI,DIV2hazardouslocations.
Thisradiocontainsasetofwiresthatprotrudethroughasingleconduithub.Onewire
isterminatedwithanRJ45connectorforEthernetconnections.Thiswirecanalso
supplypowerifattachedtoaPoEInjector.
Thesecondwiresuppliespowertotherad
ioifaPoEInjectorisnotused.Ifnotusing
thesecables,simplyterminatethem.
Toinstallthisradio….
1. PlaceaSealCapoverthetopoftheconduit.
2. Runbothwiresdownthroughtheconduit.
3. Pushtheconduitupintothepermanentlyinstalledconnectoronthebottomofthe
radio.Pushitupasfarasitwillgo.