User's Manual

RLX2 Industrial Hotspot Series

ProSoftTechnology,Inc. Page27of208
February5,2015

2. Connectthepowercable withanM12connectortothespecifiedportshown.
Note:TheRLX2‐IHNF‐Wradio canbepoweredoverEthernet(POE)withan
approvedinjectoravailablefromProSoft.Inthiscase,thePowerconnectorwould
notbeused.
IfPoEisused,pleasecapthePowerConnectorwiththesupplie
dM12Waterproof
Capbeforeinstallation.
3. ConnecttheEthernetcablethroughthePoEinjector(ifusingPoE)andthenintothe
networkswitch.
Note:Mostoff‐the‐shelfPoEInjectorsworkwiththisunitexceptforthe802.3at/
PoE+Injectors.


Note:TheM12PoEc
ableisnotincludedwiththeradiobutcanbeorderedthrough
ProSoft.