User manual

RLXIC-SV ♦ Intelligent Cellular Configuring your RLXIC-SV
RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network User Manual
Page 44 of 146 ProSoft Technology, Inc.
May 29, 2009
Tip: If you have configured the RLXIC-SV for settings different than the defaults for Bits per
Second, Data Bits, Parity, and/or Stop Bits, you will need to use your changed settings.
2 Click OK.
Connected
1 Type
AT and press ENTER. You should get a reply of "OK" or "0".
2 To see what you are typing as you type it, you will need to turn on the echo
and verbose mode. Type
ATE1V1 and press ENTER.
3 If you get a reply of "
OK", then you entered the command successfully. If you
get a reply of "
0" or "ERROR", try entering the command again.
5.3.1 AT Commands
When using a terminal application, you will need to manually type in each
command.
 For most commands, when you are entering them using a terminal
connection, you will need to preface the command with AT (exceptions are
noted), that is,
ATA which is listed as A.
 Some commands have specific parameters while other commands will take
whatever you type.
 Required variable parameters are denoted with italicized text, example, Dn.
The n is variable.
 Acceptable parameters and/or specific formats are listed with each
command.
 Most commands with parameters can be entered with ? to read the current
value (for example,
AT&D? will respond with "2" if the default has not been
changed).