User manual

Activating your RLXIC-SV on your cellular provider RLXIC-SV ♦ Intelligent Cellular
User Manual RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network
ProSoft Technology, Inc. Page 27 of 146
May 29, 2009
5 Verify ALEOS has established communication to the internal hardware.
ATI3
o Enter the activation command appropriate for your type of account. The
SID and NID are optional and only required if your account type uses
them.
o If you have the same number for the MIN and MDN or MSID:
AT*PROVISION=MSL,MDN[,SID,NID]
o If you have the different numbers for the MIN and MDN or MSID:
AT*PROVISION2=MSL,MDN,MIN/MSID[,SID,NID]
3.2.2 Using Direct Commands to the Internal Hardware
Use only if the ALEOS method is unsuccessful.
Activating the Modem
1 Set telnet timeout in to 20 minutes.
AT*TELNETTIMEOUT=20
2 Save the telnet setting.
AT&W
3 Verify ALEOS has established communication to the internal hardware.
ATI3
4 Enter the user name of your account (NAI). The user name is usually
expressed as an email address with phone number of the account (example,
[e-mail]). This information should be provided by your carrier.
You may not need this step.
AT*NETUID=[NAI]
5 Enter the password of your account. This information should be provided by
your carrier. You may not need this step.
AT*NETPW=[password]
6 Put modem into passthru mode to by-pass ALEOS. This will allow direct
communication with the wireless module for programming. Entering passthru
will take 10-15 seconds and will return an "OK" when it is complete.
AT\APASSTHRU
7 Verify you are in Passthru mode.
AT!STATUS
8 Unlock the module.
AT~NAMLCK=MSL
9 Set the MDN and MSID.