User manual

RLXIC-SV ♦ Intelligent Cellular Activating your RLXIC-SV on your cellular provider
RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network User Manual
Page 26 of 146 ProSoft Technology, Inc.
May 29, 2009
4 Click N
EXT to begin the install.
At the completion of the DUN installation, you will return to the Dial-up
Networking Connection screen. The AirLink modem should now be listed as a
connection.
Your modem is now ready to be used as a DUN device for any applications on
your computer needing a network connection. If you have DUN installed for more
than one modem, you will need to specify in your application which DUN to use.
Unless it is the only DUN, your RLXIC-SV may not be the one your computer
sees as a default.
3.2 Activating Using AT Commands
If there is no Setup Wizard for your carrier available, an alternate method to
configure and activate your RLXIC-SV is by using AT commands sent directly to
the modem with a terminal application.
Caution: It is not possible to activate the RLXIC-SV using either AceManager or AceNet.
3.2.1 Using ALEOS
1 Set telnet timeout in to 20 minutes.
AT*TELNETTIMEOUT=20
2 Save the telnet setting.
AT&W
3 Enter the user name of your account (NAI). The user name is usually
expressed as an email address with phone number of the account (example,
[e-mail]). This information should be provided by your carrier.
You may not need this step.
AT*NETUID=[NAI]
4 Enter the password of your account. This information should be provided by
your carrier. You may not need this step.
AT*NETPW=[password]