User manual

Configuration Commands RLXIC-SV ♦ Intelligent Cellular
User Manual RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network
ProSoft Technology, Inc. Page 133 of 146
May 29, 2009
 n=0 : Disabled, SIP only
 n=1 : MIP preferred
 n=2 : MIP only
Note: Your account with your cellular carrier may not support Mobile IP.
~NAMLCK=nnnnnn
The NAMLCK is the modem's 6-digit OTSL (One Time Subsidy Lock), MSL
(Master Subsidy Lock), or SPC (Service Provisioning Code). Your cellular carrier
will provide the unlock code.
 nnnnnn=6 digit unlock code
Caution: If the number is accepted by the modem, the OK result code is returned. If the number is
rejected, the ERROR result is returned. If three successive Errors are returned, the modem must
be reset by Sierra Wireless AirLink Solutions to allow any further attempts. The modem permits 99
failures of this command during its lifetime. After that, the modem becomes permanently disabled.
*EVDODIVERSITY=n
Note: If you are not using a diversity antenna, *EVDODIVERSITY should be disabled.
EV-DO Diversity allows two antennas to provide more consistent connection.
 n=0 : Disabled.
 n=1 : Allow
*PROVISION=MSL,MDN/MIN[,SID][,NID]
Tip: It is recommended to use the Setup Wizard for your carrier to provision the modem.
Provision the modem with the lock code and phone number. Cannot be
configured in AceManager.
 MSL=master lockcode
 MDN/MIN=phone number
 SID=system ID
 NID=network ID
*PROVISION2=MSL,MDN,MIN[,SID][,NID]
Tip: It is recommended to use the Setup Wizard for your carrier to provision the modem.
A second set of modem provision parameters, when the MDN and MIN (MSID)
are different or "split". Cannot be configured in AceManager.
 MSL=master lockcode
 MDN/MIN=phone number
 SID=system ID
 NID=network ID