User manual

Configuration Commands RLXIC-SV ♦ Intelligent Cellular
User Manual RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network
ProSoft Technology, Inc. Page 113 of 146
May 29, 2009
Caution: TCPT should never be 0 when using the TCP mode. A broken TCP session can result in
the modem being left with a TCP half-open connection that can only be terminated with a reset.
*ENQ=n
Outputs an ENQ [0x05] after the TCP CONNECT delayed by the Delay Connect
Response time (S221).
 n=0 : Disabled (Default).
 n=1 : Enable ENQ on CONNECT.
11.3.4 UDP
This group includes commands specific to UDP serial communications.
AIP=n
Allow IP address.
 n=0 : Allow only the IP address specified in S53 to connect when UDP auto
answer is enabled (S82=2).
 n=1 : Allow any incoming IP address to connect when UDP auto answer is
enabled (S82=2).
Note: Always subject to any Friends filters that may be defined.
HOR=n
Half-Open Response - In UDP auto answer (half-open) mode.
 n=0 : No response codes when UDP session is initiated.
 n=1 : RING CONNECT response codes sent out serial link before the data
from the first UDP packet.
Note: Quiet Mode must be Off.