User manual

RLXIC-SV ♦ Intelligent Cellular Configuration Commands
RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network User Manual
Page 102 of 146 ProSoft Technology, Inc.
May 29, 2009
11.3 Common
The groups under the heading Common encompass those commands that are
common to most RadioLinx modems.
11.3.1 Misc (Miscellaneous)
The commands of the "Misc" group are a variety of commands that do not
directly fit in other categories.
Enable Event Reporting = n
Enable or disable Event Reporting, by selecting either 1-Turn on ER or 0-Turn off
ER. If you choose to enable, click on Write, and then Refresh all to see all the ER
fields.
 n=0 : Disables
 n=1 : Enables
+++
Note: +++ is not proceeded by AT nor does it require a carriage return (enter). There must be an
idle time (set by S50) on the serial port before and after this command.
AT Escape sequence. If the RLXIC-SV is in a data mode (any mode other than
PassThru), this command causes the modem to re-enter AT command mode.
The "+" is ASCII 0x2B.+++ is not available in AceManager.
Tip: DAE=1 disables the +++ command.