User manual

RLXIC-SV ♦ Intelligent Cellular Configuration Commands
RadioLinx Intelligent Cellular Serial Modem for the Verizon Wireless CDMA Network User Manual
Page 100 of 146 ProSoft Technology, Inc.
May 29, 2009
 Data Connection Failed: The RLXIC-SV failed to connect, and it is now
waiting a set time interval before it attempts to reconnect. Verify settings to
activate the RLXIC-SV.
 Network Negotiation Fail: Network connection negotiation failed. This is
usually temporary, and often clears up during a subsequent attempt.
 Network Ready: The RLXIC-SV is connected to the 1x cellular network, and
ready to send data.
 Network Dormant: The RLXIC-SVis connected to the 1x cellular network,
but the link is dormant. It will be woken up when data is sent or received.
 No Service: There is no cellular network detected.
 Hardware Reset: The internal module is being reset. This is a temporary
state.
*NETOP?
The current cellular carrier from the modem's firmware version, for example, your
cellular provider.
*NETSERV?
The type of service being used by the modem, for example Tech.
*NETCHAN?
The current active channel number.
*NETRSSI?
The current RSSI (Receive Signal Strength Indicator) of the RLXIC-SV as a
negative dBm value.
Tip: The same information is displayed with the command S202?.
*NETERR?
The EVDO or CDMA network frame error rate.
+PRL?
Preferred Roaming List (PRL) version.
*PRLSTATUS?
The status of the most recent PRL Update.
 0 : None
 1 : In Progress
 2 : Success
 Any other value : Failure