User manual

Configuration Commands RLXIC-SG ♦ Intelligent Cellular
User Manual RadioLinx Intelligent Cellular Serial Modem for Global GPRS/GSM
ProSoft Technology, Inc. Page 109 of 136
May 29, 2009
11.3.7 PPP/Ethernet
This group includes commands specific to PPP (serial) or Ethernet connections
between the RLXIC-SG and a connected device.
*DHCPSERVER=n
Act as a DHCP server for any Ethernet device connecting to the RLXIC-SG.
DHCP (Dynamic Host Configuration Protocol) allows one device, the DHCP
server, to provide dynamic IP addresses to any other device which requests
them.
 n=0 : Disabled. The RLXIC-SG will not send out replies to DHCP requests.
 n=0 : Disabled (cannot be configured in AceManager).
 n=0 : Disables the DHCP server.
 n=1 : Enabled. The modem will act as the primary DHCP server for the
network.
 n=2 : Enabled if no other DHCP server is detected (default). If another DHCP
server is detected on the network, the RLXIC-SG will not send out replies to
DHCP requests.
 n=0 : Disabled. The RLXIC-SG will not send out replies to DHCP requests.
*HOSTAUTH=n
Host Authentication Mode: Use PAP or CHAP to request the user login and
password during PPP or CHAP negotiation on the host connection. The
username and password set in *HOSTUID and *HOSTPW will be used.
 n=0 : Disable PAP or CHAP request (Default).
 n=1 : PAP and CHAP.
 n=2 : CHAP