User manual

Configuring your RLXIC-EV RLXIC-EV ♦ Intelligent Cellular
User Manual RadioLinx® Intelligent Cellular Ethernet Gateway for Verizon
ProSoft Technology, Inc. Page 83 of 104
March 10, 2010
Field AT Command Description
SNF Enable *PPSNF
Store and Forward will cause reports to be stored up if the
device goes out of network coverage. Once the vehicle is
in coverage, the reports will be sent in bulk to the server.
 n=0: Disabled
 n=1: Enabled (default)
Use IMEI for
Device ID in
Location
Reports
*PPDEVID
Enabling this will force the use of the IMEI in the Device ID
instead of the phone number.
Use Device ID in
Location
Reports
Whether or not the device should include the 64-bit device
ID in its reports. The Device ID MUST be enabled if the
device uses a Dynamic IP.
 n=0: Disable ID.
 n=1: Enable/display ID.
SNF Reliable
Mode
*PPSNFR
Store and Forward Reliability: Reports will be retransmitted
if not acknowledged by the server.
 n=0: Disabled
 n=1: Reliable mode enabled for RAP messages
 n=2: Simple reliable mode
SNF Mode *PPSNFB
Store and Forward Behavior. When Store and forward is
enabled, the type of Store and Forward behavior is defined
by:
 n=0: Normal Store and Forward. Data is stored when
the MP is out of cellular coverage; when the MP is in
coverage, data is sent to server as soon as possible.
This is the default form MP devices with RAP version
1.3 or lower.
 n=1: Data sent only when polled. Data is stored until
polled using the Poll command sent by a server.
 n=2: Grouped Reports. Data is stored until the desired
minimum number of reports (see *PPSNFM) has been
stored. The data is then sent to the server in groups
with at least the specified number of reports.
SNF Minimum
Reports
*PPSNFM
Store and Forward Minimum Reports. Specifies the
minimum number of reports that must be stored before
they are forwarded to the server. The data is then sent to
the server in packets that contain at least this number of
reports.
 n=0-255
SNF Simple
Reliable Max.
Retries
*PPMAXRETRIES Maximum number retries when in Simple Reliable Mode.
 n=0: Disabled
 n=1-255 retries
Redundant
Server 1 IP and
Redundant
Server 2 IP
Send duplicate unreliable report to this Server.
Redundant
Server 1 Port
and Redundant
Server 2 Port
Send duplicate unreliable report to this port.