User manual

RLXIC-EV ♦ Intelligent Cellular Configuring your RLXIC-EV
RadioLinx® Intelligent Cellular Ethernet Gateway for Verizon User Manual
Page 52 of 104 ProSoft Technology, Inc.
March 10, 2010
5.7.4 USB
The RLXIC-EV is equipped with a USB port, which increases the methods by
which you can send and receive data from a connected computer. The USB port
can be set to work as either a virtual Ethernet port or a virtual serial port. A driver
installation is required to use the USB port in either mode.
By default, the port is set to work as a virtual Ethernet port.
Note: It is recommended that you use a USB 2.0 cable with your RLXIC-EV and connect directly to
your computer for best throughput.
To change the USB port to allow virtual serial port communication in
ACEmanager in the LAN > USB group, choose USB Serial as the USB Device
Mode. To disable the USB port, select Disabled from the same menu.
Note: The change to the USB mode is immediate and generally does not require a reboot.
Field AT Command Description
USB Device
Mode
*USBDEVICE Indicates which virtual mode of the USB port is set.
*USBDEVICE=1 – enable virtual Ethernet port
*USBDEVICE=0 – disable virtual Ethernet port
Device USB IP
The USB/net IP address of the RLXIC-EV. By default, this
is set to 192.168.14.31.
1 - USBNET
0 - USB Serial
2 - Disabled
Host USB IP The IP for the computer or device connect to the USB port.
USB Serial Echo
Toggle AT command echo mode when the USB is
configured for virtual serial.
0 = OFF; 1 = ON
Note: USB Serial works with Linx CDC-ACM driver.