User manual

Configuring your RLXIC-EV RLXIC-EV ♦ Intelligent Cellular
User Manual RadioLinx® Intelligent Cellular Ethernet Gateway for Verizon
ProSoft Technology, Inc. Page 49 of 104
March 10, 2010
5.7.2 Addressing
This section governs Ethernet port connections and the Public/Private mode of
all ports. Changing settings in this area requires a reboot of the RLXIC-EV after
applying any changes.
Field AT Command Description
Host Public
Mode
*HOSTPRIVMODE
Sets the Host Interface that uses the Public IP address
grated by the cellular network or if all should use private IP
addresses. All host interfaces that are not using the public
IP address will use private IP addresses.
0 = Ethernet Uses Public IP ;
1 = All Hosts Use Private IP's
2 = USB Uses Public IP
3 = RS232 Uses Public IP
Device IP *HOSTPEERIP
The Ethernet IP address of the RLXIC-EV. By default, this
is set to 192.168.13.31.
Subnet mask *HOSTNETMASK
The subnet mask indicates the range of host IP addresses
which can be reached directly. Changing this will limit or
expand the number of clients that can connect to the
RLXIC-EV. The default is 255.255.255.0 and means that
254 clients can connect to the RLXIC-EV. Using
192.168.13. as the first three octets of their IP address if
the device IP is 192.168.13.31.
DHCP Server
Mode
*DHCPSERVER
Enabled or Disabled. By default, the Ethernet DHCP server
is enabled. Disabling the DHCP server will require all
connected clients to have static IP addressing.
DHCP Network
Mask
The Netmask given to any Ethernet DHCP client.
Starting IP *HOSTPRIVIP Ethernet DHCP pool starting IP address.
Note: If you have only one computer or device connected
directly to the Ethernet port, this is the IP address it will be
assigned.
Ending IP The ending IP for the Ethernet Interface.
Link Radio
Coverage to
Interface
This will disable the specified port when there is no cellular
coverage.
1 = Ethernet; 2 = USB
Radio Link
Delay (Seconds)
The delay in seconds before the radio link goes down.