User manual

RLXIC-EV ♦ Intelligent Cellular Configuring your RLXIC-EV
RadioLinx® Intelligent Cellular Ethernet Gateway for Verizon User Manual
Page 44 of 104 ProSoft Technology, Inc.
March 10, 2010
Field AT Command Description
MSL Code ~NAMLCK
The NAMLCK is the device's 6-digit OTSL (One Time
Subsidy Lock), MSL (Master Subsidy Lock), or SPC
(Service Provisioning Code). Your cellular carrier will
provide the unlock code.
 nnnnnn=6 digit unlock code
Note: If the number is accepted by the device, the OK
result code is returned. If the number is rejected, the
ERROR result is returned. If three successive Errors are
returned, the device must be reset by RadioLinx Intelligent
Cellular Solutions to allow any further attempts. The device
permits 99 failures of this command during its lifetime.
After that, the device becomes permanently disabled.
EV-DO Diversity *EVDODIVERSITY
Note: If you are not using a diversity antenna,
*EVDODIVERSITY should be disabled.
EV-DO Diversity allows two antennas to provide more
consistent connection.
 n=0: Disabled.
 n=1: Allow
EV-DO Data
Service
*EVDODATASERV Change the allowable Network type.
 EV-DO preferred but can "fall back" on CDMA/1x
 EV-DO only, fall back disabled
 CDMA/1x only, EV-DO disabled
*PROVISION=MSL,MDN/MIN[,SID][,NID]
It is recommended to use the Setup Wizard for your carrier
to provision the device.
Provision the device with the lock code and phone number.
Cannot be configured in ACEmanager.
 MSL=master lock code
 MDN/MIN=phone number
 SID=system ID
 NID=network ID
Network
Roaming
Preference
Automatically allows home and roaming network
preference.
Auto PRL
Schedule (days)
*AUTOPRLFREQ Indicates PRL update schedule.
 n=0: Disabled
 n=1-255 days