User manual

Configuring your RLXIC-EV RLXIC-EV ♦ Intelligent Cellular
User Manual RadioLinx® Intelligent Cellular Ethernet Gateway for Verizon
ProSoft Technology, Inc. Page 43 of 104
March 10, 2010
5.6 WAN/Cellular Configuration
The WAN/Cellular tab that displays in ACEmanager, is applicable across all
RadioLinx Intelligent Cellular devices.
The WAN/Cellular section allows changes to the cellular connection and main
operating mode of the RLXIC-EV.
Note: The Network Credential and Advanced settings will appear differently and is dependent on
cellular carrier settings.
Field AT Command Description
Dormancy Idle
Timer (secs)
+CTA
Inactivity timer, in seconds. Typical network settings cause
a link to go dormant after 10 to 20 seconds of inactivity, no
packets transmitted or received. This time can be
shortened to release the physical RF link sooner when the
application only transmits short bursts.
 n=0: Allows the cellular network to determine the
inactivity timer.
 n= seconds (maximum 20 seconds)
Mobile IP $QCMIP
Mobile IP (MIP) Preferences. On a Mobile IP network, a
device connects to the network using PPP. During the
negotiation process the RLXIC-EV is NOT required to
present a username and password to authenticate
because the authentication parameters are stored in the
device itself.
 n=0: Disabled, SIP only
 n=1: MIP preferred
 n=2: MIP only
Note: Your account with your cellular carrier may not
support Mobile IP.