User manual

Configuring your RLXIC-EV RLXIC-EV Intelligent Cellular
User Manual RadioLinx® Intelligent Cellular Ethernet Gateway for Verizon
ProSoft Technology, Inc. Page 37 of 104
March 10, 2010
Field AT Command Description
Network State *NETSTATE The current network state:
Connecting To Network: The modem is in the process
of trying to connect to the cellular network.
Network Authentication Fail: Authentication to the
cellular network has failed. Verify settings to activate
the modem.
Data Connection Failed: The modem failed to
connect, and it is now waiting a set time interval
before it attempts to reconnect. Verify settings to
activate the modem.
Network Negotiation Fail: Network connection
negotiation failed. This is usually temporary and often
clears up during a subsequent attempt.
Network Ready: The modem is connected to the 1x
cellular network and ready to send data.
Network Dormant: The modem is connected to the 1x
cellular network, but the link is dormant. It will be
woken up when data is sent or received.
No Service: There is no cellular network detected.
Hardware Reset: The internal module is being reset.
This is a temporary state.
RSSI *NETRSSI
The current RSSI (Receive Signal Strength Indicator) of
the RLXIC-EV as a negative dBm value. Signal strength of
the cellular signal. The lower the number, the better the
signal strength. The exact numbers vary between cellular
carriers. However, -40dBm to -70dBm usually means the
RLXIC-EV is in an excellent coverage area.
Tip: The same information is displayed with the command
S202?.
Network
Operator
*NETOP Indicates the network the device is currently on.
Network Service
Type
*NETSERV
The type of service being used by the device, for example
EV-DO Rev A
ALEOS
Software
Version
I1
Software version of the ALEOS build currently installed in
the device.
Channel *NETCHAN The current active 1x / CDMA channel number.
WAN/Cellular
Bytes Sent
Number of bytes sent to the network since system startup.
WAN/Cellular
Bytes Rcvd
Number of bytes received from the network since system
startup.
Device Name *MODEMNAME Name of the your modem (up to 20 characters long)