User manual

Activating your RLXIC-EV on Verizon RLXIC-EV ♦ Intelligent Cellular
User Manual RadioLinx® Intelligent Cellular Ethernet Gateway for Verizon
ProSoft Technology, Inc. Page 19 of 104
March 10, 2010
3 Activating your RLXIC-EV on Verizon
In This Chapter
 Automatic Activation..............................................................................19
This chapter provides step-by-step directions for activating your RLXIC-EV on
Verizon's network.
3.1 Automatic Activation
One of the special features of your RLXIC-EV for Verizon is the ability to activate
itself automatically. When you first power on the RLXIC-EV, it will check to see if
it has been activated with account data. If it finds that it has not yet been
activated, the RLXIC-EV will attempt to retrieve the account data from the
Verizon network using Over-the-Air Service Provisioning (OTASP).
Important: You need to have an account with Verizon before you attempt automatic activation. If
you have not ordered an account from Verizon for your RLXIC-EV, it will not succeed at activating.
1 Connect the RLXIC-EV with antennas.
2 Plug the power cable to the power connector on the back panel of the RLXIC-
EV.
3 Connect your computer to the RLXIC-EV with an Ethernet cable.
4 Observe the LEDs.
5 Wait approximately 30 seconds, to allow the RLXIC-EV to initialize and go
over the air.
Caution: Do not move your RLXIC-EV while it is being programmed.
6 When the lights illuminate, your RLXIC-EV has successfully completed
OTASP and is registered on the Verizon network.