User manual

RLXIC-EH ♦ Intelligent Cellular Activating RLXIC-EH on your cellular provider
RadioLinx Intelligent Cellular Ethernet Gateway for HSUPA (3G GSM) Networks User Manual
Page 20 of 111 ProSoft Technology, Inc.
May 29, 2009
3.2.2 Connect to the Modem
1 Click the CONNECT button.
2 Select TCP,
UDP, or PPP.
Enter the connection information.
o For UDP or TCP, enter 192.168.13.31 as the IP address.
o For PPP, select the COM port to which the modem is connected.
Note: The simplest way to connect to the modem is through a USB cable. Refer to Universal Serial
Bus (USB) (page 37) for information on how to install the necessary drivers for a USB connection.
3 Enter the password. The default password will be entered for you.
4 Click OK.
3.2.3 Enter the APN
1 Select CELLULAR from the menu on the left side of AceManager (under
"Groups")
2 Type your APN in the New Value field of *NETAPN.
Optional: If you need to configure your modem for a custom APN, after entering the APN, there is
additional information you will need to enter.
a Select Misc from the menu on the left side under the Common group.
b Enter the NAI into the new value field for *NETUID and enter your network
password into the new value field for *NETPW.
3.2.4 Write the Settings to the RLXIC-EH
1 Click the WRITE button on the tool bar of AceManager.
2 Wait for the message "Write Successful" to appear in the status bar.
3 Reset the RLXIC-EH.