User guide

RLX-IH ♦ 802.11b RadioLinx Industrial Hotspot Browser
Industrial Hotspot
Page 66 of 99 ProSoft Technology, Inc.
April 10, 2007
Field Description
Mode
Indicates whether you designated the radio as a master, repeater, or
client.
Connection The status of the wireless connection.
Signal The signal strength, which in this field is a number from 0 to 15.
Hops
The number of wireless connections a radio is from the closest master
radio.
Master The MAC address of the selected radio's master radio.
Associations
The number of network elements to which a radio has a wireless
connection.
Bridges The number of repeaters to which a radio has a wireless connection.
Tx and Rx
The transmission throughput rate and the received throughput rate.
Both rates are measured in kilobytes per second (KB/s).
Software Version and
Boot Version
The versions of the radio's firmware and its boot code.
Image The image type can be Primary or Secondary.
Compression Indicates whether the radio's firmware images are compressed or not.
Ethernet The Ethernet connection status, either Attached or Detached.
Channel The channel that the radio is using, if connected.
WEP/WPA
Indicates the encryption setting on the radio. See Security settings
(page 45) for information.
5.6 View Menu
The View menu contains the following commands:
 Tool Bar (page 67)
 Status Bar (page 67)
 List View (page 67)
 Topology View (page 67)
 Zoom In (page 69)
 Zoom Out (page 70)
 Zoom to Fit (page 70)
 Print Area (page 71)
 Reset Columns (page 71)