Setup guide

6
10. Select either 64, or 128 bit encryption. Ensure this matches what you selected during the
RLX-IH Setup, step 13.
11. Select Alphanumeric: *This will say “5 characters” for 64 bit, and “13 characters” for 128
bit*. Make the appropriate selection.
12. In Key 1, type the text key you used during the RLX-IH Setup, step 13, and ensure Use
WEP Key is set to 1.
13. Click OK
After a few seconds of negotiating you should now only see the
icon. If your newly
installed RLX-PC-IB/EB is setup to obtain an IP address automatically, you can go to the
command prompt, and type ipconfig /all to see if you’ve obtained an IP address. You may
have to type ipconfig /release, followed by an ipconfig /renew. Your new IP address will be
displayed, and you will now have network connectivity.
For technical assistance, contact ProSoft Technology, Inc., Support Department using the
below contact information.
ProSoft Technology Inc.
1675 Chester Ave.
Second Floor
Bakersfield, CA 93301
United States of America
Tel: [phone]
Fax: [phone]
Web: www.prosoft-technology.com
Email: [e-mail]
Technical Support Department
Tel: [phone]
Fax: [phone]
Web: http://www.prosoft-technology.com/content/view/full/26
Email: [e-mail]