Setup guide
4
15. Click on Apply Changes.
16. Click the Close button to close the current webpage, and choose Yes to confirm.
17. Open the RadioLinx Industrial Hotspot Browser.
18. If you manually assigned an IP address to the RLX-IH, you should see that IP address in
the RadioLinx Industrial Hotspot Browser.
19. If you specified that the RLX-IH should obtain an IP address automatically, then connect
the RLX-IH to your network at this time. If you’re going into a Hub, or a Switch, be sure
to use a straight through Ethernet cable (the gray Ethernet cable provided). Disconnect
the power to the RLX-IH, and then reconnect the power. This is done to reset the
RLX-IH so it will obtain an IP address from your networks DHCP server.
20. If your laptop normally obtains an IP address from a DHCP server, change your settings
back to that configuration at this time.
2. RLX-PC-IB/EB Setup
1. Install the RLX-PC-IB/EB software from the setup CDROM.
2. Insert the RLX-PC-IB/EB into an available PCMCIA slot.
Note:
On some Windows 2000 systems, the RLX-PC card is installed as a LAN-based PC Card,
and on others, it’s installed as a Wireless LAN PC Card. The PC Card will function properly
in each case.
3. After installation of the PC Card and the drivers, you should see an icon in the
taskbar on the lower right.
Note:
Until you’re finished with the last procedure of this document, any reference to the icon
my also appear as anyone of these icons:
4. For systems that identify the PC-Card as an 802.11b Wireless Card only need to
follow this step. Open the Network Properties Page of your installed RLX-PC card, and
click on the Wireless Networks tab. Uncheck “Use Windows to configure my wireless
network settings”, and click OK.
5. Double click on the icon.