User manual
Table Of Contents
- Start Here
- Configuring the Processor with Concept
- Configuring the Processor with ProWORX
- Configuring the Processor with UnityPro XL
- To build (compile) the project:
- To verify address and driver settings in UnityPro XL:
- Setting Up the ProTalk Module
- Configuring the Module
- Diagnostics and Troubleshooting
- Reading Status Data From the Module
- The Configuration/Debug Menu
- Required Hardware
- Required Software
- Using the Configuration/Debug Port
- Main Menu
- Opening the Data Analyzer Menu
- Viewing Block Transfer Statistics
- Viewing Module Configuration
- Opening the Database Menu
- Opening the Backplane Menu
- Transferring the Configuration File from PC to PTQ module
- Transferring the Configuration File from PTQ module to PC
- Viewing Version Information
- Warm Booting the Module
- Viewing Port Communication Status
- Viewing Port Configuration
- Exiting the Program
- Database View Menu
- Viewing Register Pages
- Displaying the Current Page of Registers Again
- Moving Back Through 5 Pages of Registers
- Viewing the Previous 100 Registers of Data
- Skipping 500 Registers of Data
- Viewing the Next 100 Registers of Data
- Viewing Data in Decimal Format
- Viewing Data in Hexadecimal Format
- Viewing Data in Floating Point Format
- Viewing Data in ASCII (Text) Format
- Returning to the Main Menu
- Backplane Menu
- Data Analyzer
- Data Analyzer Tips
- LED Status Indicators
- Reading Status Data From the Module
- Reference
- Index
PTQ-LNG ♦ Quantum / Unity Platform Configuring the Module
Landis & Gyr Telegyr Interface Module
Page 58 of 103 ProSoft Technology, Inc.
May 29, 2007
Block 9995 – Time Synchronization
If the module retrieves a BLOCK ID of 9995 from the PLC after it is issued the
Command Function 32 by a master, it will place the date and time data contained
within the block into the event buffer and alter the data values for the points in the
database. Using the example data buffer of 300100 to 300199 described above
the contents of the block would look as follows:
Word Offset in
Block
Example
Address
Data Description
0 300100 0
If it completed successfully. A counter will
increment.
1 300101 Block ID 9995
2 300102 Month This field contains the month value that is set.
3 300103 Day This field contains the day value is set.
4 300104 Hour This field contains the hour value is set.
5 300105 Minute This field contains the minute value is set.
6 300106 Second This field contains the second value is set.
7 300107 MSec
This field contains the millisecond value is
set.
In your table, word zero will contain a value of zero, word one will contain the
BLOCK ID code, and word two and so on will contain the data.
6.3.7 Uploading and Downloading the Configuration File
ProSoft modules are shipped with a pre-loaded configuration file. In order to edit
this file, you must transfer the file from the module to your PC. After editing, you
must transfer the file back to the module.
This section describes these procedures.
Important: The illustrations of configuration/debug menus in this section are
intended as a general guide, and may not exactly match the
configuration/debug menus in your own module. For specific information about
the configuration/debug menus in your module, refer to The
Configuration/Debug Menu.
Required Hardware
You can connect directly from your computer's serial port to the serial port on the
module to view configuration information, perform maintenance, and send
(upload) or receive (download) configuration files.
ProSoft Technology recommends the following minimum hardware to connect
your computer to the module:
80486 based processor (Pentium preferred)
1 megabyte of memory
At least one serial communications port available
A null modem serial cable.