User manual

Configuring the Module PTQ-LNG ♦ Quantum / Unity Platform
Landis & Gyr Telegyr Interface Module
ProSoft Technology, Inc. Page 47 of 103
May 29, 2007
6 Configuring the Module
In This Chapter
¾ Before You Begin................................................................... 47
¾ Obtain the Sample Configuration Files................................... 48
¾ Edit the Sample Configuration File Sections .......................... 49
6.1 Before You Begin
This section provides the information required to configure the ProTalk module to
work with your application.
Phases I and II described how to set up a Quantum project and then add the
ProTalk module to the project.
In this phase, you will:
1 Obtain the Sample Configuration File from the ProTalk CD
2 Edit each of the sections within the LNGS.CFG file
3 Transfer the edited file to the ProTalk module
4 Obtain the Sample Configuration Files
Get the sample configuration files from the ProTalk CD.
Important: This module supports a maximum configuration file size of 128
kilobytes (131072 bytes). If the configuration file is larger than this size, the
module will not accept the download. You can reduce the size of the
configuration file by opening the file in a text editor and removing comment
lines (lines preceded with the # character).
After you move the files, right-click on each of the files and clear the READ
ONLY flag.
Move the appropriate configuration files and ladder to a location on your PC's
hard drive. We recommend C:\temp.
1 Choose Start → Programs → Accessories → Notepad.
2 In Notepad, choose File → Open.
The Open dialog appears.