User manual

Module Configuration PTQ-104S Rev2 ♦ Quantum Platform
User Manual IEC 60870-5-104 Server for Quantum
Page 86 of 195 ProSoft Technology, Inc.
February 22, 2013
Point
Value
Threshold
Determined by the deadband set in the configuration file or altered by the write
command.
Low Limit
Last reported event value - threshold.
High Limit
Last reported event value + threshold.
5.8 [I104S] > [IEC-870-5-104 IP ADDRESSES]
This section enters the IP addresses for the hosts to connect to this unit. The unit
will only accept connections from hosts listed here. This list may contain up to 10
entries between the START and END labels. The address must start in column 1,
and must be entered in standard dot notation.
The following is an example of the [IEC-870-5-104 IP ADDRESSES] section:
5.9 [I104S] > [M_SP_NA_1 104]
This section defines the monitored single-point database. This information is
sourced from the database and is transferred to the remote Client unit. Each
point indicates one of two states, 1 = Bit On, 0 = Bit Off.
This section takes the following parameters:
 Point #
 DB Address
 Group(s)
 IV DB Bit
Each point is one bit and the DB address value corresponds to the bit offset in
the module memory database. For additional information on how to set these
parameters, see the Reference chapter of this manual.