User manual

MVI56-HART ♦ ControlLogix Platform Diagnostics and Troubleshooting
HART Multi-drop Master Communication Module User Manual
ProSoft Technology, Inc. Page 67 of 171
October 13, 2011
Transferring the Configuration File from The Module to the PC
On the Diagnostics Menu this is referred to as Send Module Configuration.
Press [S] to send (upload) the configuration file from the module to your PC.
Press [Y] to confirm the file transfer, and then follow the instructions on the terminal
screen to complete the file transfer process.
After the file has been successfully uploaded, you can open and edit the file to change
the module’s configuration.
Viewing Version Information
Press [V] to view version information for the module.
Use this command to view the current version of the software for the module, as well as
other important values. You may be asked to provide this information when calling for
technical support on the product.
Values at the bottom of the display are important in determining module operation. The
Program Scan Counter value is incremented each time a module’s program cycle is
complete.
Tip: Repeat this command at one-second intervals to determine the frequency of
program execution.
Warm Booting the Module
Press [W] from the Main menu to warm boot (restart) the module.
This command will cause the program to exit and reload, refreshing configuration
parameters that must be set on program initialization. Only use this command if you must
force the module to reboot.
Exiting the Program
Press [ESC] to restart the module and force all drivers to be loaded. The module will use
the configuration stored in the module's flash memory to configure the module.
4.1.3 HART Master Menu
Redisplaying the Menu
Press [?] to display the current menu. Use this command when you are looking at a
screen of data, and want to view the menu choices available to you.