User manual

Start Here MVI56-HART ♦ ControlLogix Platform
User Manual HART Multi-drop Master Communication Module
Page 26 of 171 ProSoft Technology, Inc.
October 13, 2011
1.8 Downloading the Sample Program to the Processor
Note: The key switch on the front of the ControlLogix processor must be in the
REM or PROG position.
1 If you are not already online with the processor, open the Communications menu,
and then choose DOWNLOAD. RSLogix 5000 will establish communication with the
processor. You do not have to download through the processor's serial port, as
shown here. You may download through any available network connection.
2 When communication is established, RSLogix 5000 will open a confirmation dialog
box. Click the DOWNLOAD button to transfer the sample program to the processor.
3 RSLogix 5000 will compile the program and transfer it to the processor. This process
may take a few minutes.
4 When the download is complete, RSLogix 5000 will open another confirmation dialog
box. If the key switch is in the REM position, click OK to switch the processor from
PROGRAM mode to RUN mode.
Note: If you receive an error message during these steps, refer to your RSLogix
documentation to interpret and correct the error.