Specifications

Error/Status Data HART ♦ ProLinx Gateway
Driver Manual HART Master
ProSoft Technology, Inc. Page 43 of 119
July 7, 2009
4 Error/Status Data
In This Chapter
 HART LED Indicators ............................................................................43

Viewing Error and Status Data ..............................................................43
 Configuration Error Word Table.............................................................43

Port 0 General Status Data ...................................................................44
 Port 1 General Status Data ...................................................................44

Error/Status Data Structure ...................................................................45
 Module Error Codes ..............................................................................47
The module error/status data areas are discussed in this section. The module
contains three areas related to this data. The user defines the location of these
data sets in the virtual database of the module. The error/status data contains
module data, the six command error list data sets contain the errors associated
with each respective command list and the four slave status list tables contain
the communication status of each port’s slave devices.
4.1 HART LED Indicators
LED State Description
Green Flashing
The module either sending or receiving data over that
channel.
CH1 to CH4
Off The module is waiting to receive data on that channel.
4.2 Viewing Error and Status Data
The following topics list the register addresses that contain error and status data.
You use the Database View option to view the contents of these registers. Refer
to the ProLinx Reference Guide for detailed information on viewing error and
status registers.
4.3 Configuration Error Word Table
4.3.1 HART Configuration Error Word
Bit Code Description
0 0x0001 Enabled not set to Y or N
1 0x0002 Enable Handheld not set to Y or N
2 0x0004 Primary Master not set to Y or N