Specifications

HART ♦ ProLinx Gateway Configure the Gateway
HART Master Driver Manual
Page 36 of 119 ProSoft Technology, Inc.
July 7, 2009
Command Definition
64 Write Analog Channel Additional Damping Value
65 Write Analog Channel Range Values
66 Enter/Exit Fixed Analog Channel Mode
67 Trim Analog Channel Zero
68 Trim Analog Channel Gain
69 Write Analog Channel Transfer Function
70 Read Analog Channel Endpoint Values
71 Lock Device
72 Squawk
73 Find Device
74 Read I/O System Capabilities
75 Poll Sub-Device
76 Read Lock Device State
79 Write Device Variable
80 Read Device Variable Trim Points
81 Read Device Variable Trim Guidelines
82 Write Device Variable Trim Point
83 Reset Device Variable Trim
105 Read Burst Mode Configuration
106 Flush Delayed Responses
107 Write Burst Device Variables
108 Write Burst Mode Command Number
109 Burst Mode Control
110 Read All Dynamic Variables
3.4.10 Int. DB Address
0 to 3999
This field specifies the internal database register where the integer or packed
ASCII string values returned by the command will be placed.
If the Floating Point Word Count parameter is "-1", then all the data returned by
the HART command will be placed in this address without any formatting.
3.4.11 Int Word Count
0 to 125
This parameter specifies the number of words from the integer or packed ASCII
string data returned by a HART command that will be placed on the Virtual
Database. If this parameter is "0", no data will be written to the Database.