User's Manual

OS2400 Radio Module Exhibit 21: User Manual 3 FCC ID: OQ7OS2400

Note: The Radio’s serial port settings (baudrate, parity, data bits and stop bits) must match those

of the Configuration PC’s.

Note: A good initial transmit power is 100mW. The power may need to be adjusted as part of the

installation optimization process.

To complete the radio’s configuration select:

?? CONFIGURE RADIO

CONFIGURE RADIO button causes the download of radio parameters from the Configuration PC

to the radio. Once the configuration is complete save the configuration as prompted by the

OS2400 Setup / Diagnostics Application Software.

Note: Once a radio is configured, it is recommended that the radio be labeled with its role in the

network (Master or Remote), baud rate, channel, etc. Labeling can lessen confusion in the future.

If the radio’s configuration fails, consult the Diagnostics – Troubleshooting section.

SAVE THE RADIO’S CONFIGURATION

Once the radio has been configured, select:

?? FILE

?? CLOSE

This dialog box will appear. The name of the network

is incorporated into the filename. The *.lus is the

filename extension of each network’s database file.

The radio has just been configured. This information

must be added to the database file to keep the

database current.

Note: It is for this reason that all network design and

radio configuration be done using the Configuration

PC. When networks are modified, the OS2400 Setup

Application depends upon the retrieval of the

network’s configuration history.