User's Manual

OS2400 Radio Module Exhibit 21: User Manual 3 FCC ID: OQ7OS2400
12
These are the factory-set serial port parameters for the Configuration PC.
Change these defaults with care.
?? Baud rate: 115200 (default).
?? Parity: None (default).
?? Data Bits: 8 (default).
?? Stop Bits: 1 (default).
?? Handshaking:
It is recommended that the handshaking defaults
not be changed.
?? Xon/Xoff OFF
?? Rts/Cts ON
(Request to Send/Clear to Send)
?? Dtr/Dsr OFF
(Data Terminal Ready/Data Set Ready)
?? From the drop down list, select the COM port to be used. The term COM port
refers to the hardware connectors which allow the computer to COMmunicate
with other devices (like a printer or an OS2400 radio) through cables. Usually
the hardware connectors are located on the back of the computer.
The OS2400 Setup Application automatically determines and displays the serial ports.
NOTE:
The determination of the designation (name) of each COM port can be accomplished
several ways:
?? look for a label at the connector on the back of the PC.
?? consult the computer’s documentation.
?? experiment, trial and error.
?? check (and or adjust) the PC’s BIOS configuration.
In general, the factory set defaults will not have to be changed.
OK to accept the current settings.
For an illustration of the factory default serial port settings see Serial Port Factory
Default Settings.
SERIAL PORT FACTORY DEFAULTS ILLUSTRATED
From any of the three associated dialog boxes, select:
?? OK to confirm/enter any changes made and return to the Setup Software main
menu.
?? CANCEL to discard any changes and return to the Setup Software main menu.