User manual

ILX34-AENWG ♦ Point I/O Platform Configure the ILX34-AENWG
Wireless POINT I/O Adapter User Manual

ProSoftTechnology,Inc. Page37of209
September19,2011

2 Configure the ILX34-AENWG
In This Chapter
 CreateaNewRSLogix5000Project...................................................................37
 CreatetheNetwork...........................................................................................39
 CreatetheAdapter............................................................................................41
 AddPOINTModulesUndertheAdapter...........................................................44
 Configure1734POINTI/OModules..................................................................45
 ConfiguringWirelessSettingsinRSLogix5000..................................................49
 InstalltheAntenna
............................................................................................50
 TesttheNetworkInstallationPlan....................................................................51


2.1 Create a New RSLogix 5000 Project

Note: The following steps require RSLogix 5000 version 17 or newer, and a processor with
firmware compatible with this version of RSLogix 5000. To use the ILX34-AENWG adapter with an
earlier version of RSLogix 5000 or the processor firmware, please refer to Using the ILX34-
AENWG with Earlier Versions of RSLogix 5000 (page 195).

1 OpentheF
ILEmenu,andthenchooseNEW…
