User manual

Start Here ILX34-AENWG ♦ Point I/O Platform
User Manual Wireless POINT I/O Adapter

Page36of209 ProSoftTechnology,Inc.
 September19,2011

Verify Wireless Communication
Atthispoint,withtheEthernetcablestillattachedtotheILX34‐AENWG,gototheWIRELESS
STATISTICSwebpage,andverifythattheILX34‐AENWGislinkedtotheAccessPoint.
Afterthelinkisestablished,youshoulddisconnecttheEthernetcablefromtheILX34and
reconnectittotheAccessPoint.Fromthispointon,allcommunicationscanbedonewirelessly.

Note: If Ethernet cables are connected to both the ILX34-AENWG and the Access Point, and there
is a wireless link between these devices, a loop will be formed. Typically the Access Point detects
this loop and disconnects the wireless link. In this condition, the link LED on the ILX34-AENWG will
periodically come on and then go off. Also, the Wireless Statistics web page will sometimes show
the unit is linked and then later show that it is not.
