User manual

Start Here ILX34-AENWG ♦ Point I/O Platform
User Manual Wireless POINT I/O Adapter

Page26of209 ProSoftTechnology,Inc.
 September19,2011

Configure the IP Address with the Thumbwheel Switches
oreyoucanconnecttotheILX34‐AENWGforthefirsttime,youmustconfigureitsIPaddress.
ThesimplestwaytosettheIPaddressforyourinitialconnectionistousethethumbwheel
switchesonthefrontoftheadapter.

ThethreethumbwheelswitchesrepresentthefinaloctetfortheprivateIPaddress192.168.1.xxx
(wherexxxrepresentsthenumbersetontheswitches).
Thefactorydefaultswitchsettingis999.Usethebuttonsaboveandbeloweachnumberto
selectatemporaryIPaddresstouse.Chooseanumberbetween
001and254,takingcarenotto
duplicatetheIPaddressofanyotherdeviceonthenetwork.
NOTE: Settings 777 and 888 are reserved and used for special functions. For details, see
Restoring All Factory Default Settings (page 116).
Ifyousettheswitchestoaninvalidnumber(thatis,000oravaluegreaterthan254),theadapter
checkstoseeifyouenabledDHCP,accordingtothefollowingtable.
If DHCP is Then the adapter
Enabled AsksforanaddressfromaDHCPserver.TheDHCPserveralsoassignsother
TransportControlProtocol(TCP)parameters.
Notenabled UsestheIPaddress(alongwithotherTCPconfigurableparameters)storedin
nonvolatilememory
TheupdatedIPaddresssettingwilltakeeffectwhentheadapterispoweredup.
