User manual

ILX34-AENWG ♦ Point I/O Platform Start Here
Wireless POINT I/O Adapter User Manual

ProSoftTechnology,Inc. Page23of209
September19,2011

1.8.2 Install the Wireless Point I/O Adapter on the DIN-rail

Warning: You must follow all safety instructions when installing this or any other electronic
devices. Failure to follow safety procedures could result in damage to hardware or data, or even
serious injury or death to personnel. Refer to the documentation for each device you plan to
connect to verify that suitable safety procedures are in place before installing or servicing the
device.

1 PositiontheadapterverticallyabovetheDIN‐rail.
2 PressdownfirmlytoinstalltheadapterontheDIN‐rail,andthenturntheorangescrewto
locktheadaptorontotheDIN‐rail.

Warning: If you connect or disconnect the Ethernet cable with power applied to this module or any
device on the network, an electrical arc can occur. This could cause an explosion in hazardous
location installations.
Be sure that power is removed or the area is nonhazardous before proceeding.

3 Slidethesafetyendcapuptoremove.Thisexposesthebackplaneandpower
interconnections.

Caution: Do not discard the end cap. Use this end cap to cover the exposed interconnections on
the last mounting base on the DIN-rail. Failure to do so could result in equipment damage or injury
from electric shock.
Important: You must use series C POINT I/O modules with the ILX34-AENWG adapter. Series A
or B POINT I/O modules will not work with this adapter.

1.8.3 Connect Power to the Adapter
TheILX34‐AENWGadapterrequiresanexternalsourceofDCvoltage.TheDCsourcevoltage
shouldbe24Vnominal,witharangeof10Vto28.8V.Refertothefollowingillustrationsfor
wiringinformation.