User manual

Diagnostics and Troubleshooting ILX34-AENWG ♦ Point I/O Platform
User Manual Wireless POINT I/O Adapter

Page116of209 ProSoftTechnology,Inc.
 September19,2011

4.9 Restoring All Factory Default Settings
1 Turnmodulepoweroff.
2 Changethethumbwheelsto777.
3 Turnmodulepoweron.
4 RunBOOTPandyouwillseeaProSoftMACIDappear(00:0D:8D:XX:XX:XX).UseBOOTPto
assignanIPaddresstotheILX34.
5 Openawebbrowser,andgototheIPaddressyoujustassigned
(e.g.
http://XXX.XXX.XXX.XXX).
6 GotoConfiguration→Network→NetworkConfiguration.
7 SelectDisableforEthernetPort1.ClickApplyChangesandwaitforthechangetobewritten,
soitcanbecometheactivesetting.
8 SelectEnableforEthernetPort1.ClickApplyChanges,andwaitforthechangetobewritten,
soitcanbecometheactivesetting.
9 Turnmodulepoweroff.
10 Performtheresetprocedureappropriateforyourversionoffirmware.Fordetails,see
RestoringtheFactoryDefaultNetworkSettings(page114).

WARNING: "Ethernet Port 1" is the wireless port. If you disable Ethernet Port 2 you will lose your
wired connection to the ILX34.
