User manual

ILX34-AENWG ♦ Point I/O Platform Diagnostics and Troubleshooting
Wireless POINT I/O Adapter User Manual

ProSoftTechnology,Inc. Page109of209
September19,2011

4.6 LED Status Indicators
Attention: You must use series C POINT I/O modules with the ILX34-AENWG adapter. Series A
or B POINT I/O modules will not work with this adapter.


4.6.1 Module Status
Indication Probable Cause Recommended Action
Off Nopowerappliedtodevice Applypowertothedevice.
Flashing
Red/Green
LEDcyclepowertest(moduleself‐test)
present.
None
SolidGreen Deviceisoperatingnormally. None
FlashingRed Recoverablefaulthasoccurred:
Firmware(NVS)updatepresent.
Addressswitcheschanged.

Completefirmwareupdate.
Verifyaddressswitches.
SolidRed Unrecoverablefaulthasoccurred:
Self‐testfailurepresent(checksum
failure,orramtestfailureatcycle
power).
Firmwarefatalerrorpresent.
Replaceadapter.
