User's Manual

A2410NJ-OCM
10 dBi Omni N jack collinear for marine environment, 2.4GHz
A2412NJ3-DP
12dBi Panel N-Jack MIMO antenna 2.4GHz
A2413NJ-DP
13 dBi Directional patch panel N jack with mounting hardware 2.4GHz
A2415NJ-DY
15 dBi Directional N jack Yagi with mounting hardware 2.4GHz
A2415NJ-OC
15dBi Omni N jack collinear antenna with mounting hardware 2.4GHz
A2416NJ-DS
16 dBi Directional 120 degree sector N jack with mounting hardware 2.4GHz
A2419NJ-DB
19 dBi Directional N jack parabolic with mounting hardware 2.4GHz
A2419NJ-DP
19 dBi patch panel N jack with mounting hardware 2.4GHz
A2424NJ-DB
24 dBi Directional N jack parabolic with mounting hardware 2.4GHz
A2502S-OA
2dBi omni RP-SMA articulating 2.4/5GHz
A2506NJ-OC
6/8dBi omni N jack collinear with mounting hardware 2.4/5GHz
A2508NJ-DP
8/9 dBi directional N jack panel with mounting hardware 2.4/5GHz
A5003S-OBH
3dBi Omni RP-SMA bulkhead mount with 5' LMR195 pigtail 5GHz
A5004NBHW-OC
4 dBi Omni N BH low profile collinear antenna 5GHz
A5006NJ-OC
6dBi omni N jack collinear with mounting hardware 5GHz
A5007S3-DP
7dBi Panel RP-SMA MIMO antenna with 3 foot pigtail 5GHz
A5009NJ-OC
9dBi omni N jack collinear with mounting hardware 5GHz
A5017NJ3-DP
17dBi Panel N-Jack MIMO antenna 5GHz
A5019NJ-DP
19dBi directional N jack panel with mounting hardware 5GHz
A5024NJ-DP
24dBi directional N jack panel with mounting hardware 5GHz
A5812NJ-OC
12dBi omni N jack collinear with mounting hardware 5.8GHz
A5829NJ-DB
29dBi directional N jack parabolic with mounting hardware 5.8GHz
A2503S3-O
3/4dBi Omni RP-SMA MIMO antenna with 3 foot pigtail 2.4/5GHz
A2503S6-O
3/4dBi Omni RP-SMA Dual MIMO antenna with 3 foot pigtail 2.4/5GHz
A2506NJ3-O
6dBi Omni N-Jack Single MIMO antenna with 3 foot pigtail 2.4/5GHz
A2506NJ6-O
6dBi Omni N-Jack Dual MIMO antenna with 3 foot pigtail 2.4/5GHz
An adapter may be needed for some of the listed antennas to operate with certain radios
Antenna spacing requirements for user safety
It is important to keep the radio's antenna a safe distance from the user. To meet the requirements of FCC part
2.1091 for radio frequency radiation exposure, this radio must be used in such a way as to guarantee at least 20
cm between the antenna and users. Greater distances are required for high-gain antennas. The FCC requires a
minimum distance of 1 mW *cm2 power density from the user (or 20 cm, whichever is greater).
If a specific application requires proximity of less than 20 cm, the application must be approved through the FCC
for compliance to part 2.1093.