User's Manual

RLX2 Series ♦ 802.11a, b, g, n Start Here
Industrial Hotspots User Manual
1.2.2 LED Indicators
All radios have LED indicators on the front panel that indicate the status of the
radio while booting up and during operation. The LED states are summarized in
the following table:
Power
 While booting up
 When fully operational
RF Transmit  While transmitting over wireless
RF Receive  While receiving over wireless
Serial  When a serial cable is attached
Ethernet  When Ethernet data is being
transferred
Net  Blinks if SD card with new
configuration inserted
Mod  Blinks if SD card with new
configuration inserted
Signal Strength LEDs: SD card
inserted
   Blinks if SD card with new
configuration inserted
Signal Strength LEDs: running in Client
or Repeater Modes
  
No Signal
   Radio linked, Poor Signal
   Radio linked, Fair Signal
  
Radio linked, Good Signal
Signal Strength LEDs: running in
Master Mode
  
No radios linked
   One or more radios linked
(right LED blinking).
   DFS Channel Availability
Check in progress (all LEDs blinking
Amber)
See section 5.3 for further details regarding the LED display for various
conditions.
ProSoft Technology, Inc. Page 11 of 161
November 29, 2012