Installation Guide
1.
2.
Wall Surface
(side prole)
Drywall
Anchor
Z-Clip
Washer
Wood/
Drywall Screw
3.
1. Attach a Z-Clip to your Wave Pro Panel by screwing the
included Machine Screws into your preferred pre-drilled machine
screw inserts (for vertical or horizontal placement). The part of
the Z-Clip that lays at against the panel should be on the top.
*If you purchased additional Z-Clips to add security to the bottom of the
panel, repeat the process for the additional Z-Clip set.
2. Attach the remaining Z-Clip to the wall using the appropriate
screws/wall anchors. The part of the Z-Clip that lays at against
the wall should be on the bottom. It is recommended to position
Z-Clips on the wall using a laser/carpenterʼs level or chalk line to
ensure an even install.
*Where possible, screw into a stud or other internal wall structure.
3. When all Z-Clips are installed, position your Wave Pro Panel
against the wall with the panelʼs Z-Clip slightly higher than the
wallʼs Z-Clip, then slide the panel down until the clips are secure.
*For added security on a permanent installation, add a dab of RTV adhesive
in the Z-Clip track before mounting.