Operating instructions

Page 6
Connection
 Adjust the right or left foot to make the machine stable.
 Connect tab single-phase A.C, 100-240 VAC 50-60 Hz.
 Release the emergency button.
 Lamps are walking 1 by 1, put in a skate and then machine is ready to sharp.
 Connect the dust-cleaners hose to the machine for automatic start of dust-cleaner when
grinding. Connect dust-cleaners hose with the machines hose.
Placement
 The machine must be placed on a flat, steady workbench with a height between 80-100
cm.
 The working area must be well lit. Keep work area clear. Cluttered areas and benches
invite injuries.
Issuing
 The noise level of the machine is less than 70 dB.
 During use of the machine, dust will occur and this dust must be taken away.
 Clean the machine between every grinding.
Engagement
 For information regarding the grinding machine the responsible operator must inform other
users about safety and maintenance instruction.
 For safety reasons, modifications of the machine or its design are not allowed.
Maintenance
 The ProSharp AS 1001-Portable is manufactured for low maintenance demands.
 In your own interest and for your own safety, control and cleaning must be done before,
during and after grinding.
 Remove the plug before carrying out any adjustment, servicing or maintenance.
Important!
 All operators must read and understand original instructions regarding operation and
maintenance contained in this manual, before using the machine.
 People under 18 years of age may NOT use the machine!
 Never move the skate-holder by hand. Only use the arrows to move the skate-holder.
 Only non-flammable vacuum cleaners should be connected to the AS 1001.