Instruction manual

5
AS2001 Allpro
INSTALLATION INSTRUCTIONS
1. Unpacking and installation: Open the transportation box by unscrewing the locks on
both sides of the transportation box.
2. Place the machine on a steady table on a height between 80-100 cm.
3. Cut all cable ties.
4. Before using the machine do an ocular inspection and check the grinding wheel for any
cracks which may have been caused by the transportation.
5. Plug in the power cord.
6. Turn the main switch on and turn the emergency stop button on with the attached key.
7. Use the machine in a warm, dry and well lit room.
SAFETY PRECAUTIONS:
WARNING! When using electric tools basic safety precautions should always be followed
to reduce the risk of re, electric shock and personal injury. Read all these instructions
before attempting to operate this product and save these instructions for further use. The
use of any accessory or attachment other than the ones recommended in this instruction
manual may present a risk of personal injury.
1. Always use eye, ear and breathing protection. Always connect a vacuum cleaner to
the machine to minimize amount of dust occurring outside the machine.
2. Wear proper apparel. Do not wear loose clothing, gloves, neckties, rings, bracelets,
or other jewelry which may get caught in moving parts. Nonslip footwear is recom-
mended. Wear protective hair covering to contain long hair.
3. Do not expose the machine in rain. Do not use the machine in damp or wet locations.
Keep work area well lit. Keep work area clear. Cluttered areas and benches invite
injuries. Do not use the machine in the presence of ammable liquids or gases.
4. Guard against electric shock. Avoid body contact with earthed or grounded surfaces
(e.g. pipes, radiators, ranges, refrigerators)
5. While operating the machine, keep other persons away from the work area. Make
workshop kip proof with padlocks, master switches, or by removing starter keys.
Do not overreach. Keep proper footing and balance at all times. Do not stand on the
machine.