Instruction manual

38
SHARPENING
1. Put the skate in the machine with the toe to the left. Clamp it with the clamp handle
located to your right.
2. Press the black start/stop button located on the machines right side. Each push equals
1 cycle. You may sharpen up to 5 cycles at a time.
3. Unclamp the skate and check result.
SHARPENING FIGURE SKATES
• To sharpen gure skates you need a round toe pick protector. Its designed to protect
the toe picks on your gure skate.
• A special wheel for gure and bandy skates is also requierd. Instead of the normal
100MM EP wheel you use a 60MM wheel which helps you protect the heel of your
skate.
• With these assessories you will be able to sharpen your gure skate the same way you
sharpen a regular skate.
Both of these assessories can be ordered from our website www.prosharp.com
WARRANTY
The warranty applies for one year for materials and workmanship. The manufacturer is not
responsible for defects or faults that arise from normal usage, negligent maintenance or
other neglect, unauthorized tampering, improper use, service or repairs performed by
others than those approved by the manufacturer, as well as variations in electrical voltage
or other electrical disorders.
The manufacturer is not responsible for costs such as travel expenses, transport costs or
costs for repairs not performed by the manufacturer during the warranty period, or for
inaccessibility to the machine during the service period in connection with measures to
repair any faults covered by the warranty.
The manufacturer will not bear any costs that arise in the form of damage to skates or
other property. The buyer shall, at own risk and cost, send the machine or component
in question to the manufacturer for assessment of warranty coverage and repair. The
machine or component will be returned to the buyer at the manufacturer’s expense.