Instruction manual

Skatepal Pro

UNPACKING AND INSTALLATION

1. Place the machine on a steady bench with a work height between 80-100 cm.

2. Open the top lid by clicking on the buckles on each side of the machine.

3. Inside the lid you will nd the power cord and the vacuum extension.

4. Move the slide lid found on the right end of the machine and connect the vacuum

extension to it.

5. Connect the power cord and turn on the switch.

6. Use the machine in a warm, dry and well lit room.

SAFETY PRECAUTIONS:

WARNING! When using electric tools basic safety precautions should always be followed

to reduce the risk of re, electric shock and personal injury. Read all these instructions

before attempting to operate this product and save these instructions for further use. The

use of any accessory or attachment other than the ones recommended in this instruction

manual may present a risk of personal injury.

1. Always use eye, ear and breathing protection. Always connect a vacuum cleaner to the

machine to minimize amount of dust occurring outside the machine.

2. Wear proper apparel. Do not wear loose clothing, gloves, neckties, rings, bracelets, or

other jewelry which may get caught in moving parts. Nonslip footwear is recommen-

ded. Wear protective hair covering to contain long hair.

3. Do not expose the machine in rain. Do not use the machine in damp or wet locations.

Keep work area well lit. Keep work area clear. Cluttered areas and benches invite inju-

ries. Do not use the machine in the presence of ammable liquids or gases.

4. Guard against electric shock. Avoid body contact with earthed or grounded surfaces

(e.g. pipes, radiators, ranges, refrigerators)

5. While operating the machine, keep other persons away from the work area. Make

workshop kip proof with padlocks, master switches. Do not overreach. Keep proper

footing and balance at all times. Do not stand on the machine.

6. Never leave the machine running unattended. Disconnect all cables after using the

machine.

7. Do an ocular inspection of the machine and look for any damages made from trans-

portation.