Instruction manual
28
GRINDING OF FIGURE SKATES AND
BANDY SKATES
ALTERNATIVE 2:
1. After dressing your grinding wheel, measure your skate and set the scale knob on the
same width as your skates.
2. Put your toe pick on any of the proling dots on the skate holder. Then clamp your
skate.
Click on the ”PROFILE” button on your control-panel. Here you have three options.
Each light indicates where the skate-holder will turn back.
You choose the option suited for your skates, depending on where the toe pick on your
gure skate is located.
3. Choose number of grinding cycles by using the “SHARP” button. 1 push is worth of
1 cycle, 2 pushes is worth of 2 cycles and so on. Machine will start after choosing the
amount of cycles and will stop automatically once nished.
The grinding procedure is now successfully completed.
For more detailed instructions how to sharpen Figure and Bandy Skates, please take a look
at our Instructional Videos at www.prosharp.com