Instruction manual

20
6. Never leave the machine running unattended. Press down the emergency switch,
remove the key and disconnect all cables after using the machine.
7. Do an ocular inspection of the machine and look for any damages made from trans-
portation.
8. Store the machine properly in a dry locked-up place, out of reach of children.
9. Never yank the cord to disconnect it from the socket. Keep the cord away from heat,
oil and sharp edges. Always use the original cable delivered with your machine.
10. Avoid unintentional starting. Ensure switch is in “o” position when plugging in your
power cord.
11. This machine should only be repaired by an authorized service representative using
only original spare parts.
12. Prosharp AS 2001-Allpro is a skate sharpening machine and should only be used for
sharpening ice skates.
13. Follow the recommended maintenance instruction on page 8.
14. Disconnect machine before any maintenance. When changing accessories such as
grinding wheels and/or diamond tools. For detailed instructions for how to change the
grinding, see page 13. Other parts than those recommended by the manufacturer may
present a risk of personal injury.
15. Only original special balanced ProSharp grinding wheels may be used in the machine.
16. When the wheel has worn down to ~5” (125mm) it must be replaced with a new one.
17. Change of the wheel may only be done when the main power is turned o.
18. Please notice that the protective equipment, according to signs, must be used when
grinding with the machine.
19. The skate sharpening machine AS 2001-Allpro is equipped with grinding tools which
may cause injury.
20. The operator must stand in front of the machine.
21. Never put your hands on any moving parts while the machine is operating.
22. People under 18 years of age may NOT use the machine!
23. Never move the skate-holder by hand. Only use the arrows on the control panel to
move the skate-holder.
24. Use only non-ammable vacuum cleaners.